Product Information on Cull-Buddy Culling System

Watch The Cull-Buddy Culling System In Action!		Looking for installation directions? Click here
	Where do you put your fish after you catch it? The live well! So why not have your buoys exactly where you need them? In the live well! Each Cull-Buddy comes with the buoy holder, mounting hardware, and 6 numbered & colored buoys. The Cull-Buddy easily installs into the lid of any livewell/storage well 9"x9" or larger. The Cull-Buddy is made out of PVC type material and its mounting hardware is made of stainless steel so it resists rusting. The Cull-Buddy measures 8.5 inches wide by 11 inches long including the length of the buoys.

		Cull-Buddy's buoys are counter balanced so that the buoys do not fall out of the Cull-Buddy when driving or in rough water conditions. Your buoys will stay in place no matter what!

Installing your Cull-Buddy culling system has 3 simple steps: 1. Center the Cull-Buddy on the live well/ storage well opening that measures 9"x 9" or greater. Mark holes for pre-drilling with a pencil. 2. Using a 5/32 drill bit, drill holes as marked. 3. Insert screws from the outside of the lid, through the Cull-Buddy. Then place washers on the screws and tighten the self-locking nuts, being careful not to overtighten since this may cause the Cull-Buddy to crack. For more help....watch the video!		For Detailed Installation Directions...watch below!
		Special Installation Fiberglass Lid Installation If you have a fiberglass lid, you do not need to screw all the way through the lid. Just use the washers & half-inch self tapping screws. Do not use the screws provided & do not overtighten. Locking Lid If you have a lock on your live well, you will need to use spacers between your Cull-Buddy & the lid of the live well (see picture to the left). You will need the size spacer that is the same distance as the lock off of the lid.